JK HABITAT STORAGE SOLUTIONS

AT Jeep JK interior Cargo Rack.

Fits all 4 door JK's. Clamps to the interior roll bar. Forms an upper shelf for storage. Room underneath the shelf for you fridge, stove, and drawer system. Hardware included.

45"W x 26.25"D x 5.5"H (1143mm x 667mm x 140mm). 30 lbs (13.64 Kg.)

Cost: $557.00

Storage, Stage 1

Stage 1: Composite drawer for JK Unlimited LineX coated.
22" W x 12.25" H x 30" L, contoured to fit with rear seats in place.

Cost: $799.00

Storage. Stage 2

Composite twin top loading compartment for JK Unlimited, LineX coated with false bottom access to flex water tank below in passenger foot well (22"W x 30L" x 19" H).
Accessory compartment (7" W x 25"L x 10.5" H).

Flip up extension to allow for in cab sleeping ( 10" x 22" W).

Mechanicals panel below accessory compartment for pump switch, shower mixer, valves. (works with Stage 1 drawer. Requires removal of 60% rear seat)

Cost: $925.00

JK Habitat Kitchen:
The rear of the JK Habitat has been outfitted to accommodate a rear facing composite drawer and a double slide.

The lower slide is built to hold the JK Partner Steel Stove, and the upper slide to hold an Engel 45, a National Luna Weekender Fridge, or a ARB 50 qt . For easy of fitting a mounting plate is used to secure the fridge to the slide, it can also be bolted directly to it.

The Partner Steel Stove has been made specifically to fit the combo slide and has the controls built into the end of the unit.

JK Combo Slide: Two level fridge slide. Upper slide for fridge, lower slide for a partner steel stove. 300 lb rated lock in/out slides.

The Combi Slide is: 30"(762mm) long with the stove
15 1/2"(394mm) wide
4"(102mm) tall.

Cost: $645.00 

JK Partner Steel Stove: 2 burner high output propane stove.

Cost: $315.00 

Fast Disconnect Shower Unit

An externally mounted shower unit. Multiple uses as a shower, or as a general water source. The fitting has a clean looking appearance, it's low profile and the cover seals to keep out dust and moisture. The hose snaps into the fitting and is rotated to get the required water temperature. The External shower kit includes: Shower head and hose Mixer valve Mounting assembly 

Cost: $97.15

Shower Fit Kit:
Hoses, hose clamps to connect water tank & water heater to External Hot/Cold Shower Assembly

Cost: $ 60.00

Water Tank Heat Exchanger

A 6 liter (1.6 gallon) insulated heat exchanger. 12 volt heating element, 200W, requires 10 gauge wire and a 20 amp circuit breaker.

This unit will provide 1.6 gallons of water at 180 F (82 C) that can be blended with cold water to triple the volume of usable water. Enough warm water for a good shower.

The tank can reach full temperature after running the vehicle for 10 minutes. The tanks stores hot water, so you'll have hot water when you arrive at camp, and warm water to clean up the following morning.

This unit can be integrated with our shower mixer and pressure activated electric pump. We can provide you with typical installation instructions, provide you with the hardware to plumb it, or do the fitment at our shop.

The tank is 13.4" L x 8.7" H x 7.9" W ( 340mm x 220mm x 200mm) Weight 6.6 lb. (3.0 kg)

Cost: $654.00

The pump and shower mixer are housed in the side compartment, with the heater exchanger located in front.  

Fold Down Tray Table: The Trailgater table is made from 14 gauge (0.075") food-grade Stainless Steel, the backsplash is 0.120" Aluminum, both are CAD designed, laser cut, CNC bent, TIG (table) & MIG (Backsplash) welded and deburred. Max weight capacity is set at 40lbs.

The cutting board in made from bamboo and is stowed under the table. When needed, it simply slides out to the right or to the left to create an additional 14" wide working surface. The table is 25" x 13" and the slide out cutting board is 10" x 14" for a combined 465 square inches of surface area.

When not in use the table folds up and only utilizes 1.8” of depth from the tailgate. The cutting board conveniently slides under the table and the assembly folds up and is held in place with a single rattle free securing pin. Fits Wrangler 07-13, JK & JK Unlimited tailgates as well as many other vehicles.

Cost: $329.00  

JK Propane Bracket: 5lb Propane Bracket fitted to rear roll cage of the Jeep JK.

The bracket is used for securing the tank during transportation, not for long term storage. We recommend that the tank be removed from the vehicle when being used with the stove, and not used as permanent storage for the tank. When transporting propane make sure the vehicle is well ventilated and the interior temperature of the vehicle kept cool.

Cost: $142.00

5lb Propane Bottle

Cost: $65.00  

Other:

JK Unlimited 3rd seat pivot point and seat belt mount relocation bracket.

Cost: $95.00

Water Bladder: 13.2gal. Flexible Water Tank, 27-1/2" x 27-1/2"

Cost: $159.50

12 Volt water pump: pressure sensing pump. 120 W, 12 VDC

Cost: $165.00